Home > ALL PRODUCTS >   Tanner Digital Tire Pyrometer W/Case
	Use for tires, headers, interior hot spots, track Temps at the touch of a finger Ranges from 0-750 degrees F Easy to change 9 volt battery Laser on select models Tems and much more Built in backlight Our Price: $159.00 Product Code: T2110 TDTPW/C Tanner Digital Tire Pyro W/Case: Tanner Digital Tire Pyro W/Case [Add $10.00]

Features   Features · Excellent Night Viewing · Quick Air Release · Face Glows for Hours · Protective Bumper · 45 Degree Swivel Chuck · Large 2-1/2" Diameter Easy to Read Face Operating Instructions: Select the temperature scale Readings are displayed in either Celsius or Fahrenheit. When the thermometer is turned on, it is set to the temperature scale that was in use when the unit was last turned off. To change the temperature scale press the °C or °F key. Select the display resolution The unit allows two choices of resolution: High resolution: 0.1 °C or 0.1 °F (for measurements below 200°C or 200°F) Low resolution: 1.0 °C or 1.0 °F To select the display resolution, press the “1/0.1°” key. Hold Mode Press the “Hold” key to enter the data hold mode, and “Hold” is displayed on the screen. When the hold mode is selected, the thermometer holds the present reading and stops all further measurements. Pressing the “Hold” key again cancels the hold mode and allows further measurements to be taken. Min/Max Mode Press “Min/Max” once to begin recording Min and Max readings. Press “Min/Max” to select Min or Max. Hold button down for 2 seconds to exit Min/Max function. Offset Adjustment The offset control is set at the factory to allow for the variations found in standard thermocouples. By adjusting the Offset control you can optimize measurement accuracy for a particular thermocouple at a particular temperature. Resetting the Offset Control To return the control to the factory setting without having to recalibrate the unit: Place the probe into an ice water bath and allow the readings to stabilize. Slowly adjust the Offset control until the unit reads 0°C or 32°F. Probe Detector The red LED will be on when the probe is not inserted into the input of the meter and will turn off after the probe is inserted. If the red LED stays on when the probe is attached, the probe is inoperative. (Replace Probe)

Related Products... Custom Helmet Painting Custom Painted Helmets Price $349.00 Add Safequip Driving Suit Suit Price $159.95 Add 10' X-Form Drag Racing Chute/Complete/Black Drag Chute: $465.00 Add Team Kart Auto Racing Suit Jacket Sale Price: $265.00 Add Safequip Driving Suit Suit Price $179.95 Add

 Share your knowledge of this product with other customers... Be the first to write a review.

Browse for more products in the same category as this item: ALL PRODUCTS CHASSIS SETUP & ACC. > TIRE GAUGES & ACC. > PYROMETERS CHASSIS SETUP & ACC. > TIRE GAUGES & ACC. SHOP BY BRAND > TANNER RACING SHOP BY BRAND CHASSIS SETUP & ACC.

	Impact Racing "Team One" Jacket $375.00
	Team Kart Suit $260.00
	"Pay Up" $349.00
	ImpactMax Plus Underwear Long Sleeve Turtle Neck Top $99.00
	Charger Helmet $419.00
	"Goodwrench" $349.00
	Smart Tool Digital Level $120.00
	Safequip 120 Series 2 Layer Jackets $179.95
	Tanner Racing 2.5" Tire Gauge 30 PSI Standard $42.00